Well, but aluminum might be a little fragile for my liking. Any reason it can't be made from steel brass would be Loctite on the approximately 4īody would hold it. Part, I actually would try making it in two pieces, the main body and IĪ threaded stud into the base, thereby giving threads all the way up to the The part is a perfect candidate for a Swiss Screw Machine. I'm pretty sure that the slots can be done, too, but from the drawing, it The nut with a wrench, and then give the end of the shaftĪ tap with the butt of your screwdriver's handle, you If you hold the shaft by the slot in the screw, loosen Read the manual, and guessed wrongly about how to remove The only broken collets were broken by people that didn't It should be pretty clear that even plastic works very If you have the drawing, can you email to Subject: Re: 2465 Fan Collet ThingyĪttachments are not allowed on this group. Any reason it can't be made from steel brass would be fine, as Loctite on the approximately 4 threads in theīody would hold it. Part, I actually would try making it in two pieces, the main body and I would insertĪ threaded stud into the base, thereby giving threads all the way up to the body and I'm pretty sure that the slots can be done, too, but from the drawing, it looks like
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |